We’re in hot water now

We came back to the marina from our shakedown cruise and were enjoying a beer in the cockpit when Gwen noticed a noise. “Is the water pump on?” she asked. I went to investigate and saw that our bilge pump counter was at 13, so there was clearly water in in the bilge, and the fresh water pump was on and pumping. Uh-oh. Time to turn off the breaker for the water pump and look for the leak.

This is something that you never like to see…

Down in the engine room I could see water flowing into the main bilge from from the forward bilge area. We picked up some floorboards in the sole of our cabin and sure enough there was water all over. It quickly became apparent that it was coming from the area of the water heater underneath the master berth. We pulled off the matress and uncovered the water heater and soon noticed that the hot water shutoff valve had blown it’s top right off.

The valve in question.

Unfortunately, I did not have spares for this type of valve, or even any adapters specifically for this type of tubing. A trip to the local marine stores was fruitless, so I decided to try and repair the valve until I could find the right part. The top of the valve had separated from the threaded side. I thought I might be able to use superglue to repair it. Nope, it was one of those plastics that makes superglue not super. Next was the old stand-by, rescue tape. This is a self-annealing tape, that when wrapped tight adheres to itself and generally does a pretty good job stopping leaks. I wasn’t sure it would work on this hot water component but it was worth a shot until I could find a better solution.

The attempted fix.

When we put the piece back in place, it leaked a little bit. I wrapped it a bit more throroughly and it seemed to hold even with the water heater refilled and using some hot water. It held overnight and was dry when we looked at it in the morning.

The fitting back in place, wrapped with Rescue Tape.

The tubing is 1/2″ diameter PEX, which is fairly common on boats of this vintage. In retrospect, it was probably a mistake to look for an exact replacement for this particular type of valve with those tiny barb connectors. There are all kinds of valves and connectors for PEX type tubing, but they all clamp down on the outside of the tube and don’t have a barb that goes into it. I thought there would be a chance that might find a valve, or at least some connectors, at the local Home Depot or Plomeria. No such luck. I’ve ordered a selection of different couplings for 1/2″tubing to be shipped to a freight forwarder in San Diego and trucked down to La Paz.

A small upside in this little unexpected project is that I needed to replace the Anode (that stops corrosion) in the water heater, but have been putting it off because it’s a pain to get to…

4 thoughts on “We’re in hot water now”

  1. “I was enjoying a beer in the cockpit” is to a cruising blog as “It was a dark and stormy night” is to a murder mystery. You just know something bad is going to happen. But thanks to the resourcefulness of Captain Larry and Dr. Gwen, all leaks are plugged, all steering systems set straight, all batteries recharged and all anxieties tranquilized. It’s all blue skies, following seas and happy endings on Miss Miranda!

    Like

Leave a Reply to Larry O'Keefe Cancel reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

This site uses Akismet to reduce spam. Learn how your comment data is processed.

%d bloggers like this: